Bronze Under The Counter Nano Filtration System

The Bronze Under The Counter Nano Filtration System comes with:

• 10" Melted Spray (5um)

• 10" Granular Activated Carbon (GAC/UDF)

• 10" Activated Carbon Block

• 10" T33 Taste and odour Filter

• Nano Membrane

• Pressure Protection Valve

Specifications:

• Flow Rating: 200 Gallons Per Day (GPD) / 700 Litres Per Day (LPD)*

• Maximum Pressure: 6 bar / 90psi

• Maximum Operating Temperature: 4 - 45°C

• Country of Origin (System and Components): Taiwan

• Country of Origin (Nano Membrane): United States of America

• Warranty: 1 Years*

The Bronze Nano Filtration System Includes the following:

• 5 Stage Nano Filtration system (with or without a Booster Pump)

• Nano Filtration Membrane

• Standard 6 Month Filter set for Municipal water (Sediment, GAC, & Activated Carbon Block)

• Pressure Protection Valve 

 Benefits:

• Maintenance is easy and low cost

• Filtered water tastes and smells great

• Promotes a healthy lifestyle

• Hidden away out of sight, only a chrome tap is visible.

• Removes calcium (lime or kalk) from water

• Flushing of the membrane is done automatically

• Preserve the natural minerals in the water

• Delivers up to 700 liters of filtered water per day

Bronze Nano Filtration system Stages: 

• Stage 1: 10 Inch Sediment Filter - Removes Particles, Dirt, Sand, Mud, Rust, and other large visible Particles in the water.

• Stage 2: 10 Inch Granular Activated Carbon (GAC) - Absorbs Chlorine and Organic molecules (bad odours) from the water. 

• Stage 3: 10 Inch Activated Carbon Block - Further Reduces Chlorine and Organic Molecules in the source water. Also comes with a 5 micron carbon to capture any carbon that breaks off.

• Stage 4: Nano Filtration Membrane - Removes bacteria, viruses, pesticides, and herbicides. The Nano Membrane also reduces the mineral content by only half, preserving at lot of minerals in the water. The Nano will also remove Kalk / Hardness from the water.

• Stage 5: T33 taste and odour filter - Absorbs any organic molecules that come off of the Nano membrane.    

Keep in mind:

• The system has a water wastage rate of 1:1 due to constant flushing of the membrane, so for every 1 litre of clean, filtered water produced, 1 litre will be used to flush the system.

• An important thing to remember before installing any filtration system is to check, which pipe under the counter is bringing the water to the tap and what size the source piping is. The standard household piping size is normally ½ inch (12.7mm) or ¾ inch (19 mm) thick. Some older houses have copper piping instead of newer systems and in such cases special attachments will be required to install the Nano to the copper piping. In order to ensure that you do not have to buy additional adaptors due to the connections not matching the piping, please check what type and size your piping is before ordering a filtration system.

• A hole will have to be drilled into the counter or table where the NF’s tap will be placed.

• The filters all have a certain life span and must be replaced to ensure that the system works effectively, specifically the Sediment filter, Granular Activated Carbon, Carbon block and T33 Carbon (Taste and odour filter) which must be changed every 6 months.

• The Nano system requires a water pressure of between 3 and 6 bars (50 to 100 psi) to operate. If your water pressure is lower than 3 bar (- 50 psi), we recommend that you consider the Nano system with the booster pump. 

• These units are designed for up to 400ppm water and will dramatically lose efficiency as the mineral content climbs.